Workshop desk

What to measure before a bike leaves the shop

Eight notes on motorcycles, scooters and commuter e-bikes: pre-delivery inspection, homologation files, break-in oil, CVT wear, battery packs, controllers, charging heat and fleet durability.

8 notes12.2k wordsUpdated 18 Nov 2026
12.2kWords across the notes
13Sections per note, average

All notes

Pre-delivery · compliance · drivetrain · e-drive · fleet

01 · Pre-delivery

A pre-delivery inspection on a 150 cc sport bike that a dealer can defend

A pre-delivery inspection is a measurement routine: torque audit, runout, chain alignment, brake bleed and a recorded road test. Here is the sequence and the numbers.

1609 words7 min
02 · Compliance

Building a homologation file a customs officer and a regulator can both read

Homologation is a document set, not a sticker. What a 150 cc sport bike file needs, which test reports expire, and where shipments stall at the port.

1512 words7 min
03 · Break-in

Reading the first oil sample from a 200–250 cc twin without guessing

The first oil change on a new 200–250 cc twin carries more information than any later service. How to sample, which metals matter, and when a spike means a defect.

1506 words7 min
04 · Drivetrain

Measuring CVT belt wear on an adventure-style scooter instead of waiting for the slip

Scooter CVT belts fail slowly and then suddenly. How to measure width, cord exposure, glazing and roller wear, and the interval that keeps a fleet running.

1506 words7 min
05 · E-drive

Battery pack acceptance for commuter e-bikes, measured before the first charge

Pack acceptance is not a voltage check. Capacity, cell balance, BMS cut-off and weld quality decide whether a commuter e-bike survives its first winter.

1512 words7 min
06 · Controls

Testing e-bike controllers, throttles and brake cut-offs before a rider meets traffic

Most e-bike control failures appear as an unexpected surge or a dead throttle. A test sequence for PAS, brake cut-off, waterproofing and fault codes.

1500 words7 min
07 · Charging

Thermal testing the charge path: port, cable, charger and pack

Charge-path heat is the most common precursor to an e-bike pack fire. How to measure port temperature rise, connector resistance and charger termination.

1522 words7 min
08 · Durability

Running a 150–200 cc commuter fleet durability test without a test track

A durability protocol for commuter motorcycles using real routes, defined loads and scheduled teardowns, with the measurements that predict fleet cost.

1497 words7 min

What this desk does

Records, not opinions

Acceptance is a measurement

A motorcycle or an e-bike is ready when a torque value, a runout, a capacity test or a temperature rise says so. Each note here names the instrument, the acceptance band and the field that belongs on the delivery record.

Numbers you can defend

Figures are planning values taken from workshop practice and published specifications. Where a value depends on the unit in front of you, the note says so instead of inventing a universal tolerance.